06-12-2012 04:17 PM
Hello i have a BASYS2 and I was using the FPGA normally and try to schedule this with Digilent ADEPT, suddenly came to me "The program had failed," and I keep my PC recognize the Basys2.
He had already worked with her and I never had this problem appeared, now if I can connect and work with the program you have in the ROM but the PC does not recognize it, I mean the only USB is operating as a power source
Sorry for my english - Google Traductor.
12-23-2012 11:35 PM
I think you are trying to say that fpga board is no longer recognized by adept software.I'm in a similar situation.After a blackout , adept is not detecting my basys2 board and says "initialization failed".Also I have observed some strange behaviour like the device detected as CPLD.(when power switch is off , and "init. failed" when on.)
I am very hopeless about this because , I think fpga is damaged beyond repair but , before giving up ; I 'm eager to listen any recommendations.