06-25-2012 09:35 PM
I got xc6vlx240T xilinx FPGA.. I ve completed till Configure Target device successfully but facing problems in the ISE IMpact window.
In IMpact window after performing the Initialise chain , i get a warning saying no JTAG device found and check Cable set up.. And when i add the bit file i get only one device and if i try to program the device its not able to auto detect my device and again gives the same warning..
please help me.. '
07-18-2012 01:07 AM
are u using usb platform cable 2 i.e the red coloured device from xilinx or directly u r connecting the wire to the kit, and also check ur wire connection if there is some loose connection that has occured, if u r using the red device pls check that the green light glows after converting from yellow when it has been detected by the host PC.
07-30-2012 08:51 AM
You should read ORT manual prior to do anything !
Solder the wires to jtag pins, power on phone and launch software again.
As for korean phones, you should try a sim card inside, probably already unlocked ;)
ps. X1 unlock is supported till ORT version v1.09