I'm trying to figure out how to configure the JTAG for SDK version 13.4 - no joy.
There are two identical FPGAs on the chain - SDK tosses its lunch when it sees that - here's the message (exactly as from SDK - it duplicated that section, not me!) - How do I tell SDK to use the 1st FPGA on the chain, and ignore 2nd?
Unexpected error while launching program:
JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
1 44250093 10 XC6VLX240T
2 44250093 10 XC6VLX240T
MicroBlaze Processor Configuration :
-------------------------------------
Version............................8.20.b
Optimization.......................Performance
Interconnect.......................AXI-LE
MMU Type...........................No_MM
No of PC Breakpoints...............1
No of Read Addr/Data Watchpoints...0
No of Write Addr/Data Watchpoints..0
Instruction Cache Support..........off
Data Cache Support.................off
Exceptions Support................off
FPU Support.......................off
Hard Divider Support...............off
Hard Multiplier Support............on - (Mul32)
Barrel Shifter Support.............on
MSR clr/set Instruction Support....on
Compare Instruction Support........on
Data Cache Write-back Support......off
Fault Tolerance Support............off
Stack Protection Support...........off
JTAG chain configuration
--------------------------------------------------
Device ID Code IR Length Part Name
1 44250093 10 XC6VLX240T
2 44250093 10 XC6VLX240T
MicroBlaze Processor Configuration :
-------------------------------------
Version............................8.20.b
Optimization.......................Performance
Interconnect.......................AXI-LE
MMU Type...........................No_MMU
No of PC Breakpoints...............1
No of Read Addr/Data Watchpoints...0
No of Write Addr/Data Watchpoints..0
Instruction Cache Support..........off
Data Cache Support.................off
Exceptions Support................off
FPU Support.......................off
Hard Divider Support...............off
Hard Multiplier Support............on - (Mul32)
Barrel Shifter Support.............on
MSR clr/set Instruction Support....on
Compare Instruction Support........on
Data Cache Write-back Support......off
Fault Tolerance Support............off
Stack Protection Support...........off
