Timing Analysis

[czahner]

I am attempting to run the Generate Post-Place & Route Static Timing process. Every process up to that point completes successfully.  Here is the output from running the Generate Post-Place & Route Static Timing process:

Started : "Generate Post-Place & Route Static Timing".
Running trce...
Command Line: trce -intstyle ise -v 3 -s 3 -n 3 -fastpaths -xml XC6SLX150.twx XC6SLX150.ncd -o XC6SLX150.twr XC6SLX150.pcf -ucf XC6SLX150.ucf
Loading device for application Rf_Device from file '6slx150.nph' in environment
/opt/Xilinx/13.1/ISE_DS/ISE/.
   "XC6SLX150" is an NCD, version 3.2, device xc6slx150, package fgg676, speed
-3

Analysis completed Tue May  1 10:30:03 2012
--------------------------------------------------------------------------------

Generating Report ...

Number of warnings: 0
Total time: 9 secs 

Process "Generate Post-Place & Route Static Timing" failed

 After looking at this post, I verified my .xpi file contents:

PROGRAM=PAR
STATE=ROUTED
TIMESPECS_MET=YES

 Does anyone have further advice on how to get this process to complete?

[czahner]

Also, the FPGA is a Spartan-6. The OS is Red Hat.

[bwade]

I suggest that you take this question to the Timing Analysis forum which covers TRCE issues.

[endab]

What happens if you run TRCE from command line? You can more information on this in the the command line reference guide page 177.
http://www.xilinx.com/support/documentation/sw_manuals/xilinx13_4/devref.pdf