Hello
We've recentlu bought ML402 board and started with Getting start tutorial
http://www.xilinx.com/support/documentation/boards_and_kits/ug083.pdf
1) We checked CF-card. It isn't empty, there are firmwares and some images
2) We set CFG ADDR DIP-switch in 000111
3) We set SW12 in SYS ACE position
4) Then we turned on power and pressed SYS ACE button.
But led didn't set in
"♦ Bus Error 1 and 2 = off
♦ FPGA INIT = green
♦ FPGA DONE = green
♦ System ACE “Err” = off
♦ System ACE “Stat” = green"
We rather didn't see err-led blinking
"Note: When the CF card is ejected or not installed, the System ACE “Err” LED blinks."
When we press RST-button err-led go out, and when we let off button, err led become shining again, not blinking.
What do we do wrong?
