I am building a boot image , including U-boot .
( My board is an Enclustra Board with Zynq 7020)
My question is :
What is the correct line for the bif file?
( I want to load U-boot at the 1st address of DDR , which is 0x10 0000).
[load = 0x100000, startup = 0x100000]C:\Bootgen_result\u-boot.elf
Or that one:
In other words, do I need to fill the "load" field ?
Thanks by advance.
Bootgen should be smart enough to recognize the load address from a .elf. No loadaddress required.
The load attribute is really only necessary for binary files.