cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
673 Views
Registered: ‎01-02-2019

Cora z7-10 SD card boot

I'm trying to make my cora z7-10 run a .bin file when booting up, but haven't been able to. I use a 8GB kingston micro sd. When using "program target" in vivado my .bin files work as they should, but it's still volatile as when I press the srst button on the board, or unconnect then reconnect the power it doesn't run the code on boot up.

Some one suggested I format the sd to FAT32 then load the .bin as "boot.bin" on the SD directly, which didn't work.

I tried to check wether the SD is suported by vivado, but I couldn't find any of the information about my SD to refrence the information xilinx offers.

0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
580 Views
Registered: ‎10-11-2011

I suggest to take a look at AR# 59476.

read REBOOT_STATUS and BOOT_MODE registers after the boot failure.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos