cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
oceanlogic
Visitor
Visitor
491 Views
Registered: ‎05-25-2009

Creating boot image with Vivado 2019.1 : create button inactive

Jump to solution

I followed this tutorial with Vivado 2019.1. Everything is fine, looks pretty much the same, except at the very end when I need to create the boot image. If you look at 7:36, once I add the FSBL.elf, the "Create Image" button below becomes active. Not for me.

And it doesn't change when adding the .bit and the other .elf .

Any ideas ?

0 Kudos
1 Solution

Accepted Solutions
oceanlogic
Visitor
Visitor
484 Views
Registered: ‎05-25-2009

Never mind, I needed to fully specify the .bif output path. Putting simply output.bif probably ended up in some installation directory with no write permisison. Anyway, with a well specified path, the button is now highlighted.

View solution in original post

1 Reply
oceanlogic
Visitor
Visitor
485 Views
Registered: ‎05-25-2009

Never mind, I needed to fully specify the .bif output path. Putting simply output.bif probably ended up in some installation directory with no write permisison. Anyway, with a well specified path, the button is now highlighted.

View solution in original post