cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
sanjeev.hathe
Visitor
Visitor
516 Views
Registered: ‎09-18-2019

Problem in UBOOT running while program flash

 

 

Hi,

I am trying to program flash on XAZU2EG using sdk but getting "Problem in running UBOOT" error:

Initially, I thought it could be quad spi configuration issue but the quadspi config. looks fine; pls see the attached snapshot.

 

Does anyone had the same issue? Any help would appreciated.

Thanks in advance

Sanjeev

UBOOT_Error.png
Quad_SPI.png
0 Kudos
2 Replies
abommera
Xilinx Employee
Xilinx Employee
443 Views
Registered: ‎10-12-2018

Hi @sanjeev.hathe ,

For debug purposes, the Debug Environmental Variable XIL_CSE_ZYNQ_DISPLAY_UBOOT_MESSAGES can be set to 1. See (Xilinx Answer 59272) for more details.

Please also enable FSBL debug prints and run FSBL application which is used to program QSPI flash through JTAG and check your uart console whether it is completely executed or not.

Please refer to below answer record for more details

https://www.xilinx.com/support/answers/68656.html

Thanks & Regards
Anil B
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos
pierrel8922
Visitor
Visitor
360 Views
Registered: ‎03-26-2019

Hi,

I did have the same issue on my Zynq7000 board.

The root cause was the DDR interface that wasn't functionnal.

Uboot needs your DDR interface to be functionnal.

Regards,

Pierre

0 Kudos