cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
ADMU_1312
Visitor
Visitor
383 Views
Registered: ‎06-21-2021

Unable to do JTAG flashing in Xilinx ultrascale+ MPSOC(XCZU3EG). The error is "Problem in running uboot"

Jump to solution

Hello,

We are trying to to do JTAG flash but we receive the following error.

Problem in running uboot

Flash operation failed.

Please find the complete log below:

ADMU_1312_0-1624511446145.png

We also took the UART log while doing the flash process. Pasting it below:

ADMU_1312_1-1624511738187.png

Please let us know how to resolve this issue.

0 Kudos
1 Solution

Accepted Solutions
abommera
Xilinx Employee
Xilinx Employee
322 Views
Registered: ‎10-12-2018

Hi @ADMU_1312 ,

By looking into your flash programming log, the current boot mode is QSPI. Please try with JTAG boot mode while QSPI flash programming.

 

Thanks & Regards
Anil B
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
3 Replies
abommera
Xilinx Employee
Xilinx Employee
323 Views
Registered: ‎10-12-2018

Hi @ADMU_1312 ,

By looking into your flash programming log, the current boot mode is QSPI. Please try with JTAG boot mode while QSPI flash programming.

 

Thanks & Regards
Anil B
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

0 Kudos
ADMU_1312
Visitor
Visitor
289 Views
Registered: ‎06-21-2021

I configured my board into JTAG boot mode by shorting the required pins. But still the Flash happens in QSPI boot mode. Do I need to do something else apart from required hardware setup?

0 Kudos
abommera
Xilinx Employee
Xilinx Employee
232 Views
Registered: ‎10-12-2018

Hi @ADMU_1312 ,

You can change boot mode to JTAG in fsbl application and try. Please refer to AR# 70548 for your reference.

Thanks & Regards
Anil B
-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------
0 Kudos