cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
badFITimage
Explorer
Explorer
709 Views
Registered: ‎09-06-2019

bootloader compatibility across Zynq Ultrascale+ Packages

Jump to solution

Hi,

If I generate a boot image for a particular Ultrascale+ part (pmufw, aft, u-boot, fsbl) will this same image work on another ultrascale part (assuming no difference in Zynq PS configuration and no PL present)? So if we are using a Zynq Ultrascale+ Package X and attempt to load it on Zynq Ultrascale+ Package Y again with the same exact PS configuration and no PL will this work?

Since it is just a hard core I want to assume that given the configuration is correct this should work, is this assumption valid?

Thanks!

0 Kudos
1 Solution

Accepted Solutions
denist
Xilinx Employee
Xilinx Employee
558 Views
Registered: ‎10-11-2011

Yes, assuming identical PS configuration and no PL.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

3 Replies
katsuki
Xilinx Employee
Xilinx Employee
659 Views
Registered: ‎11-05-2019

 

Hello @badFITimage 

Is your question something like:

 

With a design that does not use PL, using only PS,

Can the Boot Image created for MPSoC ZU2EG be booted with MPSoC ZU3EG?

 

If yes, maybe OK.

 

Thank you

Yoichi

========================================================================
This forum is based on the cooperation of everyone who participates.
Kindly note - Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.
========================================================================


Don’t forget to reply, kudo, and accept as solution. If starting with Versal take a look at our Versal Design Process Hub and our Versal Blogs
0 Kudos
badFITimage
Explorer
Explorer
588 Views
Registered: ‎09-06-2019

Hi @katsuki,

Yes, specifically with a design with no PL, can the boot image be created for ZU7EG vs ZU2EG.

0 Kudos
denist
Xilinx Employee
Xilinx Employee
559 Views
Registered: ‎10-11-2011

Yes, assuming identical PS configuration and no PL.

-------------------------------------------------------------------------
Don’t forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post