cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
h_upadhyay
Contributor
Contributor
470 Views
Registered: ‎08-11-2019

zedboard Done Pin Does not go high

Capture1.PNG

Hello,

I am designing with zedboard OEM Zynq-7000 SoC xc7Z020. Whenever i configure ZEDBOAED (PL part ) with my PC  at last  after 88% it shows error with a messege "your done pin is not high - configuration failed ".

can anyone tell me what is the problem ?

 

Thanks in advance.

0 Kudos
Reply
1 Reply
stephenm
Moderator
Moderator
400 Views
Registered: ‎09-12-2007

can you open XSCT (Xilinx -> XSCT console), and do the following

  • connect
  • fpga -f <path to the bitstream>.bit

What do you see here?

0 Kudos
Reply