cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
2,745 Views
Registered: ‎06-03-2010

Time constraint

An integration will be done on every 1024 points, then a divider need to be done on the integration results. By using the Cordic divider, it take quite long time to refresh the result. As the attached screen, I cannot compare or confirm the result is correct, Also, I need to control that every 1024 points, there will be a divider result come out. MMay you give any suggestion, thanks.

ss.png
0 Kudos
1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
2,725 Views
Registered: ‎08-01-2007

You can use the "To Workspace" to dump the results and compare them.

 

You can also add a delay to the output of the Simulink bock to try and match the latency of the CORDIC divider.

Chris
Versal ACAP: AI Engines | Embedded SW Support

---------------------------------------------------------------------------
Don’t forget to Reply, Kudo, and Accept as Solution.
---------------------------------------------------------------------------
0 Kudos