problem with hardware cosimulation using JTAG for ZCU104 Evaluation Kit

[surajit_sarkar]

I am  using vivado 2020.1 and system generator same version(2020.1).When I am using a matlab simulink model with a system generator , I am facing problems with the Hardware co-simulation (JTAG ) interface. The hardware co simulation is showing not active (JTAG).

Please help me.

I have attached  screenshot  picture for my problem .

[ravidapu · Accepted solution]

Hi Surajit,

Thanks for writing to us. System generator does not support HW co-simulation for all the boards that are showing up in the board chooser. If HW co-sim JTAG option is disabled for any boards which means for those boards, HW co-simulation is not supported

Regards,

Raju A