cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
SoajanII
Visitor
Visitor
309 Views
Registered: ‎11-25-2020

Zybo Z7-10 & DPU Support

Jump to solution

Hello

Planning to learn more about Convolutional Neural Network (CNN) inference applications on FPGA but I'm quite new to this subject. An expert suggested me to work with either DPU or Vitis. And after some search, realized that cheapest board option is Zynq 7000 family, and DPU.  So I found a relatively cheap Zybo Z7-10 ARM board from a local seller (got a very limited budget). Planning to buy it.

According to the link:

https://www.xilinx.com/products/intellectual-property/dpu.html 

states Zynq-7000 is supported. But I want to make sure Zybo Z7-10 is a valid option for CNN applications. Can you confirm?

Also, any suggestions for this newbie is highly welcomed

Thank you

0 Kudos
Reply
1 Solution

Accepted Solutions
graces
Moderator
Moderator
226 Views
Registered: ‎07-16-2008

a, DPU does support Zynq-7000 families.

However, the current Vitis AI runtime is not compiled for 32-bit arch, and therefore is not compatible with Zynq-7000.

You may use the legacy DNNDK toolchain.

A previous related discussion: https://forums.xilinx.com/t5/AI-and-Vitis-AI/Vitis-AI-for-Zynq7000-family-devices/m-p/1100570#M3915

 

-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post

2 Replies
SoajanII
Visitor
Visitor
235 Views
Registered: ‎11-25-2020

Could you please answer this quiz question? Just type a or b, nothing more

 

 Zybo Z7-10 has DPU support or not?

a) Yes, it does

b) No, it doesn't

0 Kudos
Reply
graces
Moderator
Moderator
227 Views
Registered: ‎07-16-2008

a, DPU does support Zynq-7000 families.

However, the current Vitis AI runtime is not compiled for 32-bit arch, and therefore is not compatible with Zynq-7000.

You may use the legacy DNNDK toolchain.

A previous related discussion: https://forums.xilinx.com/t5/AI-and-Vitis-AI/Vitis-AI-for-Zynq7000-family-devices/m-p/1100570#M3915

 

-------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
-------------------------------------------------------------------------

View solution in original post