UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor sandeepcrl
Visitor
448 Views
Registered: ‎09-03-2017

vivado 2017.1 BPI Flash programming error

Hi,

I am using PC28F128P33B Flash with Artix 7 devices. I am getting unable to query common flash interface error.

Support for this BPI flash for Artix 7 devices was not there till Vivado 2016.1.

Does Viado 2017.1 supports PC28F128P33B Flash?

Regards,

B Sandeep.

0 Kudos
5 Replies
Xilinx Employee
Xilinx Employee
403 Views
Registered: ‎06-06-2018

Re: vivado 2017.1 BPI Flash programming error

Hi @sandeepcrl,

Yes, PC28F128P33B is supported in Vivado 2017.1. 

Please refer page318 of UG908.

Regards,

Deepak D N

----------------------------------------------------------------------------------------------

Please reply or give kudo or mark it as an Accepted Solution.

---------------------------------------------------------------------------------------------

0 Kudos
Visitor sandeepcrl
Visitor
390 Views
Registered: ‎09-03-2017

Re: vivado 2017.1 BPI Flash programming error

I am getting unable to query common flash interface error while programming flash from Artix 7.
0 Kudos
Moderator
Moderator
381 Views
Registered: ‎01-15-2008

Re: vivado 2017.1 BPI Flash programming error

can you provide the complete vivado programmer log file for the issue you are facing.

can you recheck your BPI interface signals are proper by referring to UG470 for the bpi configuration section

0 Kudos
Xilinx Employee
Xilinx Employee
379 Views
Registered: ‎06-06-2018

Re: vivado 2017.1 BPI Flash programming error

Hi @sandeepcrl,

 

Please share the complete error log file.

 

The Indirect programming core sends a CFI query to the flash before carrying out any info. You will see this message when this fails. Try the following -

 

Reduce cable speed(Try reducing it to 3MHz or lower)

Check schematic connections

Check Flash is powered correctly

 

These are common causes of this issue.

Regards,

Deepak D N

------------------------------------------------------------------------------------------------

Please reply or Give kudo or Mark it as an Accepted Solution.

------------------------------------------------------------------------------------------------

0 Kudos
Highlighted
Visitor sandeepcrl
Visitor
361 Views
Registered: ‎09-03-2017

Re: vivado 2017.1 BPI Flash programming error

Mfg ID : 0 Memory Type : 0 Memory Capacity : 0 Device ID 1 : 0 Device ID 2 : 0
Performing Erase Operation...
Erase Operation failed.
ERROR: [Labtools 27-3161] Flash Programming Unsuccessful
ERROR: [Common 17-39] 'program_hw_cfgmem' failed due to earlier errors.

Reduced cable speed didn't help.

Schematic connections are ok.
Power supply to the Flash is stable.
0 Kudos