UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor 5glab
Visitor
187 Views
Registered: ‎03-05-2019

Implementing FFT using Vivado

Hello everyone.

I am new to the field of FPGA, hence, apologies for trivial doubts.

As a first task, I am trying to implement FFT on the ZCU 102 board using Vivado. I have gone through the documentation and tried out the relevant procedures but haven't achieved any ouput so far. 

It would be helpful if someone here could outline the procedure for this task.

0 Kudos
1 Reply
Xilinx Employee
Xilinx Employee
120 Views
Registered: ‎09-18-2018

Re: Implementing FFT using Vivado

Hi @5glab ,

Are you using the Vivado FFT IP for this . If so, Can you share the configuration of the IP and also some more information about your design.

Please refer to Xilinx PG109 for more information on the FFT IP, which also has a demo test bench.

0 Kudos