01-09-2019 12:19 PM
Are you connected over the serial port? If so, you need to set the DISPLAY variable properly before running the application:
01-27-2019 11:51 PM
how to link the ssh to the ultra96 board? i have the same question with you , and when the system up , it display "wlan0 link is not ready and cannot open display,thanks!!
01-28-2019 07:44 AM
How are you connected to the board? Do you have a DisplayPort monitor connected?
02-01-2019 05:59 AM
02-14-2019 01:05 AM
The DNNDK in Ultra96 board can't display，how do you connect to the network and connect to ssh?
02-14-2019 10:01 AM
You can use a USB network adapter.
Or you can follow the instructions here to setup the wireless network from the command line. I was successful with the WPA instructions:
Here is what it boiled down to for my situation:
1st time only:
wpa_passphrase <SSID> <PASSWORD>
copy the generated text into a new file called /etc/wpa_supplicant.conf
wpa_supplicant -B -i wlan0 -c /etc/wpa_supplicant.conf
OR for static IP
ifconfig wlan0 <ipaddress> netmask 255.255.255.0
02-14-2019 07:25 PM
Thanks a lot, I can now connect to the wireless network. But still can't be displayed on the display
02-14-2019 07:30 PM
I would try a couple of different monitors and cables. The display should come up at boot automatically.
02-14-2019 11:53 PM