02-14-2014 01:38 AM
Hi everybody, i am trying to do the labs in ug940 guide. After generated the bitstream and exported hardware to SDK, i
start to do the lab2. I download the bitstream successfully, and then try to open the hardware target, but when i connect
the vcse_server, it stopped at the following post. (Over an half hour, it still can not go ahead).
Does someone can give me some suggestions, and i would be very appreciate!
02-15-2014 09:29 AM
Which OS are you working up on?
Is the board connected locally?
02-16-2014 10:50 PM
I am sorry that my reply is so late and many thanks for your reply! Actually, i had solved this problem from this thread (
). I should run the vcse_server in the ISE Command Prompt to start the server first and then open the hardware session
in Vivado GUI. Now i can connect Vivado cse_server successfully.
02-18-2014 02:17 AM
Good to know that you were able to overcome the issue.
Please mark your previous post as Answer. This will help other forum users.
03-03-2014 10:03 PM
I had this problem and also some errors (cannot open vcse_server) when opening the server in the Vivado Hardware manager.
Closed Vivado, cycled my development board, still occurred
I fixed it by simply ending the vivado and vcse_server processes in the task manager, then restarting Vivado and the hardware manager.