UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Scholar ronnywebers
Scholar
182 Views
Registered: ‎10-10-2014

How to create your own custom board files for Vivado?

Jump to solution

Is there any information available on how to create your own board files? i.e. to setup DDR4 memory, some fixed interfaces on the board, have drop down boxes for LEDs, switches, other interfaces, ... 

In general I can see 3 files associated with (eval) boards like the Zedboard, Picozed, ZCU102, ...  :

* board.xml

* part0_pins.xml

* preset.xml

So I'm looking for info on the syntax, naming conventions, all possible parameters that can be put into these files, ... . Are there any templates to start from, or do people start from an eval board that resembles a bit your own board, or ... ?

** kudo if the answer was helpful. Accept as solution if your question is answered **
0 Kudos
1 Solution

Accepted Solutions
Moderator
Moderator
171 Views
Registered: ‎01-16-2013

Re: How to create your own custom board files for Vivado?

Jump to solution

@ronnywebers

 

Check Appendix A in below UG:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2018_3/ug895-vivado-system-level-design-entry.pdf#page=100 

 

You can take existing board files in the XIlinx install directory as reference :

<install_dir>/Vivado/<version>/data/boards/board_files/

 

--Syed

---------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.

Did you check our new quick reference timing closure guide (UG1292)?
---------------------------------------------------------------------------------------------
Tags (1)
2 Replies
Highlighted
172 Views
Registered: ‎01-22-2015

Re: How to create your own custom board files for Vivado?

Jump to solution

Hi Ronny,

I havn't created board files before.  However, I see that Appendix-A of UG895 has quite a lot of information.

Cheers,

Mark

Moderator
Moderator
172 Views
Registered: ‎01-16-2013

Re: How to create your own custom board files for Vivado?

Jump to solution

@ronnywebers

 

Check Appendix A in below UG:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2018_3/ug895-vivado-system-level-design-entry.pdf#page=100 

 

You can take existing board files in the XIlinx install directory as reference :

<install_dir>/Vivado/<version>/data/boards/board_files/

 

--Syed

---------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.
Give Kudos to a post which you think is helpful and reply oriented.

Did you check our new quick reference timing closure guide (UG1292)?
---------------------------------------------------------------------------------------------
Tags (1)