cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
tester11
Contributor
Contributor
1,245 Views
Registered: ‎12-24-2017

Locked IP and untable to select for upgrade

Jump to solution

I changed my board type and run upgrade_ip [get_ips *] and still got 2 modules that can't be changed/selected in the gui for upgrading

0 Kudos
1 Solution

Accepted Solutions
arpansur
Moderator
Moderator
1,717 Views
Registered: ‎07-01-2015

Hi @tester11,

 

Can you please check the IP paths and add the IP definition to the project?

Thanks,
Arpan
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

3 Replies
arpansur
Moderator
Moderator
1,718 Views
Registered: ‎07-01-2015

Hi @tester11,

 

Can you please check the IP paths and add the IP definition to the project?

Thanks,
Arpan
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

hemangd
Moderator
Moderator
1,237 Views
Registered: ‎03-16-2017

Hi @tester11,

 

You need to figure out where the ip was stored and if its repository back to the list of ip reposistory. Go to project settings , IP repositories and check if the ip location is there and if not then add it.

 

Regards,

hemangd

Regards,
hemangd

Don't forget to give kudos and mark it as accepted solution if your issue gets resolved.
tester11
Contributor
Contributor
1,233 Views
Registered: ‎12-24-2017
Thanks
0 Kudos