cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
6,398 Views
Registered: ‎11-06-2013

Logic 0 and 1 in Vivado IPI

Jump to solution

Hi,

 

How can I connect an input pin of an instantiated IP ot logic0 or logic1 in IP integrator? Doesn't seem very intuitive or obvious.

 

Thanks,

Chandan

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
9,746 Views
Registered: ‎02-06-2013

Hi

 

Have a look at the below post

http://forums.xilinx.com/t5/Vivado-TCL-Community/Connecting-signals-to-ground-in-Vivado-block-design/td-p/345507

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------

View solution in original post

2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
9,747 Views
Registered: ‎02-06-2013

Hi

 

Have a look at the below post

http://forums.xilinx.com/t5/Vivado-TCL-Community/Connecting-signals-to-ground-in-Vivado-block-design/td-p/345507

Regards,

Satish

--------------------------------------------------​--------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful.
--------------------------------------------------​-------------------------------------------

View solution in original post

Observer
Observer
6,367 Views
Registered: ‎11-06-2013

Hi Satish,

 

The "constant block" solution in the link you pointed me to works perfectly. Thanks!

 

Chandan

0 Kudos