cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
kangsungsik
Explorer
Explorer
473 Views
Registered: ‎11-20-2018

Overall direction and method of design with zynq.

Jump to solution

Hi. I'm beginner of zynq. 

When I was designing with hdl on spartan6, I drew a timing diagram and designed a state machine to make the desired signal

from the desired state.

So, I've already designed a state machine. However, I am not sure because I am going to use this state machine in combination

with the aurora ip and gpio ip of xilinx. I want to design to interact with gpio1 in some states and gpio2 in others state. 

(i mean that read value from gpio to PL side in specific state.)

For do that, do i design a state machine in custom axi ip? Can i control it only with hdl? Or do I have to control it with C code in SDK?

 

I'm sorry that the question is not clear because I don't know well.

Thanks.

0 Kudos
1 Solution

Accepted Solutions
reshmaakhil
Explorer
Explorer
426 Views
Registered: ‎12-05-2016

Hi,

If you need a good start in zynq please refer http://zedboard.org/content/microzed-chronicles.

you will get answer for yor question from this. 

Regards,

Reshma 

 

View solution in original post

1 Reply
reshmaakhil
Explorer
Explorer
427 Views
Registered: ‎12-05-2016

Hi,

If you need a good start in zynq please refer http://zedboard.org/content/microzed-chronicles.

you will get answer for yor question from this. 

Regards,

Reshma 

 

View solution in original post