UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer aroytman
Observer
619 Views
Registered: ‎12-07-2017

ZCU102 PL programming

Jump to solution

 Hello all,

 

I have some general beginner's questions on PL loading.

I need to do this for a proprietary RTOS.

Will appreciate pointers to relevant material or short, high level guidelines:

 

1. Is the CSUDMA the only way to load bitstream to PL (i.e. via PCAP) or there are alternatives?

2. Is Petalinux using this interface or something else can be used as well?

3. Is u-boot using this interface or something else can be used as well?

4. If there is another way, besides the one described in ug1085 - where can I find the documentation on that?

 

Thank you very much

0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
749 Views
Registered: ‎10-11-2011

Re: ZCU102 PL programming

Jump to solution

CSUDMA is the only way for the processors in the PS to program the bitstream.

Take a look at XilFpga library.

\SDK\2017.4\data\embeddedsw\lib\sw_services\xilfpga_v3_0\doc

1 Reply
Xilinx Employee
Xilinx Employee
750 Views
Registered: ‎10-11-2011

Re: ZCU102 PL programming

Jump to solution

CSUDMA is the only way for the processors in the PS to program the bitstream.

Take a look at XilFpga library.

\SDK\2017.4\data\embeddedsw\lib\sw_services\xilfpga_v3_0\doc