cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Contributor
Contributor
6,112 Views
Registered: ‎01-27-2008

An error message when generate the netlist

Jump to solution

Dear all

 

When I am going to generate the netlist, the problem showed as below: 

 

Running synthesis...
bash -c "cd synthesis; ./synthesis.sh"

./synthesis.sh: line 2: $'\r': command not found

./synthesis.sh: line 4: $'\r': command not found

Release 9.1i - xst J.30
Copyright (c) 1995-2007 Xilinx, Inc.  All rights reserved.

ERROR:Xst:427 - Entry File system_xst.scr
 not found
./synthesis.sh: line 11: syntax error: unexpected end of file
make: *** [implementation/system.ngc] Error 2


Done!

 

 

I don't know why there is a such problem. Is that relay to the licences ?

 

Thank you. 

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
6,966 Views
Registered: ‎08-02-2007

Hello,

 

Can you check if this AR works http://www.xilinx.com/support/answers/24134.htm

 

Regards,

Hem.

----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
3 Replies
Highlighted
Xilinx Employee
Xilinx Employee
6,967 Views
Registered: ‎08-02-2007

Hello,

 

Can you check if this AR works http://www.xilinx.com/support/answers/24134.htm

 

Regards,

Hem.

----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

0 Kudos
Highlighted
Newbie
Newbie
4,910 Views
Registered: ‎11-12-2008

Hello,

 

Exactly the same problem, and the AR solution doesn't works for me. (system variable SHELLOPTS with value igncr doesn't change anything)

 

Thank you

Message Edited by cidacadvir on 11-12-2008 06:43 AM
0 Kudos
Highlighted
Newbie
Newbie
4,232 Views
Registered: ‎04-17-2009

I know this is old now, but I had the same problem and the AR fixed it.  I did have to close EDK and start it up again before the fix went into effect, however. 

 

8. If XPS was open, restart XPS so that it will recognize the new environment variable. 

0 Kudos