cancel
Showing results for 
Search instead for 
Did you mean: 
Voyager
Voyager
3,327 Views
Registered: ‎07-28-2008

How to configure xparameters.h generation for MicroBlaze system, and customer driver into BSP?

Jump to solution

Dear community,

 

I had myself pcore hardware design (not created by EDK pcore wizard) copied to ./pcores and added to system. I guess maybe I didn't write any device driver yet. libgen generated xparameters.h file contains only two line about my pcore (_BASEADDRESS & _HIGHADDRESS)

 

no _NUM_INSTANCE, nor canonical constants. I am just wondering about what's the standard workflow to have Xilinx Standard configuration constants populated in xparameters.h file (File Format and Naming Convetions mentioned in xilinx_drivers_guide.pdf)

 

The next question is how to have my custom driver merged into bsp management?

 

Thanks,

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Xilinx Employee
Xilinx Employee
4,742 Views
Registered: ‎08-02-2007

Re: How to configure xparameters.h generation for MicroBlaze system, and customer driver into BSP?

Jump to solution

Hi,

 

So the recommended flow is to include the driver of your custom peripheral when configuring your BSP. To do this follow the procedure mentioned here. http://www.xilinx.com/support/answers/35443.html

 

If you dont assign any driver, it will take generic/none by default.

 

Here is a link which helps you configure your BSP.

http://www.xilinx.com/support/documentation/sw_manuals/xilinx12_3/SDK_Doc/tasks/sdk_t_config_bsp_internal.htm

 

--Hem

 

 

 

----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post

1 Reply
Highlighted
Xilinx Employee
Xilinx Employee
4,743 Views
Registered: ‎08-02-2007

Re: How to configure xparameters.h generation for MicroBlaze system, and customer driver into BSP?

Jump to solution

Hi,

 

So the recommended flow is to include the driver of your custom peripheral when configuring your BSP. To do this follow the procedure mentioned here. http://www.xilinx.com/support/answers/35443.html

 

If you dont assign any driver, it will take generic/none by default.

 

Here is a link which helps you configure your BSP.

http://www.xilinx.com/support/documentation/sw_manuals/xilinx12_3/SDK_Doc/tasks/sdk_t_config_bsp_internal.htm

 

--Hem

 

 

 

----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

View solution in original post