cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
alvaro27
Adventurer
Adventurer
2,749 Views
Registered: ‎09-26-2007

Reading .mpd file

Jump to solution

Hello people,

 

 

I would like to know how I can read parameters ("PARAMATER ......") from a .mpd file and write them on a xparameters.h  (XPAR_PARAMETER....)  file. 

 

 

 

 

Thanks 

0 Kudos
1 Solution

Accepted Solutions
alvaro27
Adventurer
Adventurer
3,313 Views
Registered: ‎09-26-2007

Hello again,

 

I have just found out how to do it. The solution is a tcl prodecure (there is a very useful example in the psf reference manual, mdd section). The disadvantage is that now I have two tcl procedures for my IP, one is for the hdl generic parameters (hardware) and the other one is for the

xparameters.h file (software).

 

 

Thanks

View solution in original post

0 Kudos
1 Reply
alvaro27
Adventurer
Adventurer
3,314 Views
Registered: ‎09-26-2007

Hello again,

 

I have just found out how to do it. The solution is a tcl prodecure (there is a very useful example in the psf reference manual, mdd section). The disadvantage is that now I have two tcl procedures for my IP, one is for the hdl generic parameters (hardware) and the other one is for the

xparameters.h file (software).

 

 

Thanks

View solution in original post

0 Kudos