cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
yinlinlijuan
Adventurer
Adventurer
5,905 Views
Registered: ‎03-14-2012

a probblem with ug933

Hi all,

 

In the page 64 of ug933, there are some words as below,

 

• There is no automatic training for aligning command/address to clock, but a fixed
offset is programmable and can be used if necessary. Skew between CK and
address/control should be minimized, as indicated in Table 5-9.

 

 

Now I want to set this "a fixed offset" as mentioned above, but in this ug933 it doesnot tell me where and how I can set this offset.

 

Can you tell me ?

 

Thanks. 

 

Ryan.

0 Kudos
0 Replies