UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Adventurer
Adventurer
168 Views
Registered: ‎09-30-2017

2017.3 u-boot: Reported FPGA is not identical to actual one

Hello,

Using petalinux for 2017.3 I created FSBL, U-boot, Bl131, PMUFW and burned them to SPI flash. 

Upon boot I got the following messages:

Xilinx Zynq MP First Stage Boot Loader
Release 2017.3 Jan 20 2019 - 20:16:26
NOTICE: ATF running on XCZU9EG/silicon v4/RTL5.1 at 0xfffea000, with PMU firmware

U-Boot 2017.01 (Jan 20 2019 - 20:15:49 +0200) Xilinx ZynqMP ZCU102 revB

I2C: ready
DRAM: 1 GiB
EL Level: EL2
Chip ID: xczu9eg

The problem:

My FPGA is: Xczu9cg (and not Xczu9eg)

When I tried to load bit file under u-boot I got the following message:

ZynqMP> fpga loadb 0 0x10000000 0x1
design filename = "rfp_fpga_top;UserID=0XFFFFFFFF;Version=2017.3"
fpga_loadbitstream: Wrong bitstream ID for this device
fpga_loadbitstream: Bitstream ID xczu9cg-ffvc900-1-i, current device ID 0/xczu9eg

Can you please help ?

Attached the HDF file. 

Thank you,

Zvika 

0 Kudos