cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
salahuddin_93
Visitor
Visitor
4,867 Views
Registered: ‎01-18-2015

Boot preloaded Linux from SPI flash

Hi, 

I've bought a Trenz Electronic TE0720 Zynq module, where it should be preloaded with Linux inside SPI flash (PetaLinux I guess). I tried to connect the board with JTAG to Hterm software, but couldnt get anything response on the PC. Is there any command I should type to be able to load the linux kernel from SPI? 

 

Thanks :)

Tags (4)
0 Kudos
2 Replies
smarell
Community Manager
Community Manager
4,853 Views
Registered: ‎07-23-2012

Please make sure of the following things-

1. The boot strap mode pins were set to QSPI mode.
2. The UART drivers are installed on your machine to see the prints.

-----------------------------------------------------------------------------------------------
Please mark the post as "Accept as solution" if the information provided answers your query/resolves your issue.

Give Kudos to a post which you think is helpful.
0 Kudos
karikalan
Visitor
Visitor
4,098 Views
Registered: ‎11-03-2015

Hi,

 

I just started working with Trenz Electronic TE0720 Zynq module.

This board was already used by some another person.

 

I am able to boot the board in QSPI mode, its working fine.

I have a folowing doubt,

1) Whether it is containg preloaded Linux image or not. How to check whether it is preloaded image?

2) Is preloaded Linux image itself petalinux?

 

Thanks in advance :)

0 Kudos