cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer
Observer
204 Views
Registered: ‎11-21-2019

Failed to start raise network interface on custom board

Jump to solution

Hi,

I work with custom board (zynq-7035) and use petalinux 2018.3 version. My custom board's ethernet chip is atheros-ar8035. So I used this link for enabling some kernel configuration.( https://forums.xilinx.com/t5/Embedded-Linux/Adding-Qualcomm-Atheros-ath10-support-to-petalinux/td-p/922086)

 

system-user.dtsi

/include/ "system-conf.dtsi"
/ {

};

&gem{
compatible = "cdns,zynq-gem", "cdns,gem";
reg = <0xe000b000 0x1000>;
status = "okay";
interrupts = <0 22 4>;
clocks = <&clkc 30>, <&clkc 30>, <&clkc 13>;
clock-names = "pclk", "hclk", "tx_clk";
#address-cells = <1>;
#size-cells = <0>;
phy-mode = "rgmii-id";
phy-handle = <&phy0>;

phy@0 {
compatible = "atheros,ar8035";
device_type = "ethernet-phy";
reg = <0x0>;
linux,phandle = <0x4>;
phandle = <0x4>;
};
};

It failed. How can I fix it?

Screenshot from 2020-02-13 19-10-46.png

Thanks,

Esra.

0 Kudos
1 Solution

Accepted Solutions
Observer
Observer
140 Views
Registered: ‎11-21-2019

Re: Failed to start raise network interface on custom board

Jump to solution

I solved this problem.

petalinux-config -c kernel

Device Drivers -> Network device support -> Ethernet driver support→PHY device support and infrastructure→ at803x(atheros qualcom)

 

And I delete node that added in system-user.dtsi. It fixed, when I enabled at803x option. 

View solution in original post

0 Kudos
1 Reply
Observer
Observer
141 Views
Registered: ‎11-21-2019

Re: Failed to start raise network interface on custom board

Jump to solution

I solved this problem.

petalinux-config -c kernel

Device Drivers -> Network device support -> Ethernet driver support→PHY device support and infrastructure→ at803x(atheros qualcom)

 

And I delete node that added in system-user.dtsi. It fixed, when I enabled at803x option. 

View solution in original post

0 Kudos