cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
avcon_lee
Voyager
Voyager
177 Views
Registered: ‎07-17-2014

How to start telnet program automatically

Jump to solution

hi, everyone

I use my own board, similar to zcu102.

When the program starts from SD card, PC can ping the board. But telnet doesn't work, show connection failure.

The only way is through the serial port into the program system, through the telneted & command, using the command of Telnet + IP on PC can connect successfully.

Now I want to ask how to make telnet program run automatically after power on?

Is there any relevant setting in petalinux-config / petalinux-config - C rootfs/ petalinux-config -c kernel ?

0 Kudos
1 Solution

Accepted Solutions
stephenm
Xilinx Employee
Xilinx Employee
152 Views
Registered: ‎09-12-2007

You can just create a script that sets this up, and add this into your rootfs to execute upon boot:

petalinux-create --template install:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2020_2/ug1144-petalinux-tools-reference-guide.pdf

 

View solution in original post

0 Kudos
1 Reply
stephenm
Xilinx Employee
Xilinx Employee
153 Views
Registered: ‎09-12-2007

You can just create a script that sets this up, and add this into your rootfs to execute upon boot:

petalinux-create --template install:

https://www.xilinx.com/support/documentation/sw_manuals/xilinx2020_2/ug1144-petalinux-tools-reference-guide.pdf

 

View solution in original post

0 Kudos