UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor koju155
Visitor
3,373 Views
Registered: ‎11-02-2016

PetaLinux U-Boot: Phy is not detected

U-Boot 2016.07 (Jan 25 2017 - 14:30:53 +0100) Xilinx ZynqMP ZCU102 revB

DRAM: 2 GiB
EL Level: EL2
Chip ID: xczu9eg
MMC: sdhci@ff160000: 0
SF: Detected N25Q512A with page size 512 Bytes, erase size 128 KiB, total 128 MiB
*** Warning - bad CRC, using default environment

In: serial
Out: serial
Err: serial
Bootmode: QSPI_MODE
Net: ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii
PHY is not detected GEM PHY init failed No ethernet found. U-BOOT for ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii mdio_register: non unique device name 'gem' ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii mdio_register: non unique device name 'gem' ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii mdio_register: non unique device name 'gem' ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii mdio_register: non unique device name 'gem' No ethernet found. ZYNQ GEM: ff0e0000, phyaddr 1, interface gmii mdio_register: non unique device name 'gem'

I get following output from U-Boot, when I create a PetaLinux Project without modification.

 

Any hints where to start for solving this problem?

0 Kudos
3 Replies
Observer thburghout
Observer
1,643 Views
Registered: ‎10-27-2017

Re: PetaLinux U-Boot: Phy is not detected

I'm having the same issue on Zync-7000. Did you solve it already? It might help me.
0 Kudos
Moderator
Moderator
1,610 Views
Registered: ‎09-12-2007

Re: PetaLinux U-Boot: Phy is not detected

Are you using the zcu102, or a custom board?
0 Kudos
Observer thburghout
Observer
1,552 Views
Registered: ‎10-27-2017

Re: PetaLinux U-Boot: Phy is not detected

I'm using a custom board (based on the zedboard afaik) with the zynq xc7z010. I actually posted a separate question https://forums.xilinx.com/t5/Embedded-Linux/Zynq-7010-u-boot-PHY-is-not-detected/td-p/804993

Even though OP uses a different board, his output is nearly (except for the GEM address) identical to mine.
0 Kudos