UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer rschuller_cds
Observer
391 Views
Registered: ‎10-28-2019

ZCU106 Petalinux not running

I have been working with the ZCU106 and following the UG1209 Embedded Design Tutorial. I have the proper memory settings. The hello world steps with the a53 and r5 ran fine. I have had no issues until the running the Petalinux image. On the serial output I get:

Xilinx Zynq MP First Stage Boot Loader
Release 2019.1 Dec 5 2019 - 17:26:28

Then nothing else.

The large DONE LED has been red throughout this testing in both JTAG boot and SD Card boot dip switch settings.

I have gone through this tutorial using the ZCU102 and had no issues.

Thanks

0 Kudos
6 Replies
Observer rschuller_cds
Observer
387 Views
Registered: ‎10-28-2019

Re: ZCU106 Petalinux not running

Also, I am using the ZCU106 2019.1 bsp to build the Petalinux image.
0 Kudos
Visitor arfayes
Visitor
310 Views
Registered: ‎10-15-2019

Re: ZCU106 Petalinux not running

did you find a solution for your problem?
301 Views
Registered: ‎07-23-2019

Re: ZCU106 Petalinux not running

 

@rschuller_cds 

BSP 2019.1, are you using Vivado and Petalinux 2019.1 as well? You must

 

Observer rschuller_cds
Observer
282 Views
Registered: ‎10-28-2019

Re: ZCU106 Petalinux not running

Yes, I have been using both Vivado and Petalinux 2019.1 as well. I also tried using the prebuilt images contained in the BSP. Those were met with the same results.

0 Kudos
197 Views
Registered: ‎07-23-2019

Re: ZCU106 Petalinux not running

do you have any other board to try and discard/ confirm it's a hardware problem, for example, the DDR failing?

Observer rschuller_cds
Observer
146 Views
Registered: ‎10-28-2019

Re: ZCU106 Petalinux not running

After some assistance with Xilinx support it was found that my board has hardware issues and is being RMA'd. Thanks for the responses!