12-05-2019 10:06 AM
I have been working with the ZCU106 and following the UG1209 Embedded Design Tutorial. I have the proper memory settings. The hello world steps with the a53 and r5 ran fine. I have had no issues until the running the Petalinux image. On the serial output I get:
Xilinx Zynq MP First Stage Boot Loader
Release 2019.1 Dec 5 2019 - 17:26:28
Then nothing else.
The large DONE LED has been red throughout this testing in both JTAG boot and SD Card boot dip switch settings.
I have gone through this tutorial using the ZCU102 and had no issues.
12-06-2019 08:36 AM
Yes, I have been using both Vivado and Petalinux 2019.1 as well. I also tried using the prebuilt images contained in the BSP. Those were met with the same results.
12-09-2019 04:01 AM
do you have any other board to try and discard/ confirm it's a hardware problem, for example, the DDR failing?
12-16-2019 03:22 PM
After some assistance with Xilinx support it was found that my board has hardware issues and is being RMA'd. Thanks for the responses!