cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Visitor
Visitor
72 Views
Registered: ‎09-02-2020

about DTG Settings in petalinux 2020.1

Jump to solution

I am trying to use petalinux 2020.1 and i have a board based on 7z045ffg900

and when i read UG1144 page 25 it says I need to change MACHINE_NAME in DTG Setting

The possible values are: ac701-full, ac701-lite, kc705-full, kcu105, zcu1275-revb, zcu1285-
reva, zc1751-dc1, zc1751-dc2, zc702, zc706, avnet-ultra96-rev1, zcu100-revc, zcu102-
rev1.0, zcu104-revc, zcu106-reva, zcu111-reva

which one should i choose to fit my board?

thank you for your reply!

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Moderator
Moderator
53 Views
Registered: ‎11-09-2015

HI @firesuiry 

If your board is not a Xilinx board you do not have to select any of this.

This setting is used to get the DT nodes required for the board peripherals. If you are not using any of these board, it does not make sense to select ny of them.

You can keep the default name or add your custom name


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos
2 Replies
Highlighted
Moderator
Moderator
54 Views
Registered: ‎11-09-2015

HI @firesuiry 

If your board is not a Xilinx board you do not have to select any of this.

This setting is used to get the DT nodes required for the board peripherals. If you are not using any of these board, it does not make sense to select ny of them.

You can keep the default name or add your custom name


Florent
Product Application Engineer - Xilinx Technical Support EMEA
**~ Don't forget to reply, give kudos, and accept as solution.~**

View solution in original post

0 Kudos
Highlighted
Visitor
Visitor
44 Views
Registered: ‎09-02-2020

thank you for your help

0 Kudos