UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Visitor vale_marche
Visitor
1,174 Views
Registered: ‎01-16-2018

peek and poke don't work with Petalinux

Jump to solution

Hi,

I am using a ZC702 board to carry out my tests with Petalinux.

The other day, while deploying the original base TRD, rdf0286-zc702-zvik-base-trd-2015-4, on the board,

I wanted to use peek and poke commands to access GPIOs, but they didn't work - the shell was returning "command not found" messages. (I tried it for the first time with this design.)

However, shortly before that, I successfully used peek and poke with another Petalinux design, viz. 2015.4-zc702.

Does anyone knows what might be missing in the former TRD to support peek/poke, and how Petalinux shall be configured to get them installed and working?

Regards, Valery

0 Kudos
1 Solution

Accepted Solutions
Visitor vale_marche
Visitor
1,493 Views
Registered: ‎01-16-2018

Re: peek and poke don't work with Petalinux

Jump to solution

Hi Shabbir,

thank you for the quick tip - that's been it, of course!

(Actually, I had briefly sought for something like that in the petalinux config, but just overlooked).

Kind regard,

Valery

0 Kudos
2 Replies
Moderator
Moderator
1,160 Views
Registered: ‎12-04-2016

Re: peek and poke don't work with Petalinux

Jump to solution

Hi 

 

Check in your petalinux-config -c rootfs ---> apps ---> peekpoke, whether these packages are enabled? If not enable and rebuild the images and boot.

 

 

 

 

Best Regards

Shabbir

0 Kudos
Visitor vale_marche
Visitor
1,494 Views
Registered: ‎01-16-2018

Re: peek and poke don't work with Petalinux

Jump to solution

Hi Shabbir,

thank you for the quick tip - that's been it, of course!

(Actually, I had briefly sought for something like that in the petalinux config, but just overlooked).

Kind regard,

Valery

0 Kudos