cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
changliu
Visitor
Visitor
188 Views
Registered: ‎09-21-2020

petalinux started with a SD card and placed the file system in the SD card partition, but encountered problems at startup

The petalinux system was created and the SD card was successfully started, but subsequent changes want to put the file system on the SD card, according to the tutorial changes after the problem, prompted can not identify the mmcblk0p2(179,2). At the same time, for some reason, the profile is marked red. My configuration and print information are shown in the figure.

微信图片_20200921180459.jpg
微信图片_20200921180540.jpg
微信图片_20200921180514.jpg
微信图片_20200921180403.jpg
微信图片_20200921180529.jpg
0 Kudos
Reply
2 Replies
evatrostaz
Participant
Participant
173 Views
Registered: ‎07-13-2020

Check if your SD Card is not locked by mechanical switch.
I had similar problem with ZCU106 board - https://www.xilinx.com/support/answers/73079.html

0 Kudos
Reply
changliu
Visitor
Visitor
146 Views
Registered: ‎09-21-2020

Thank you, I use the development board "zedboard", Is it the same way to modify it
0 Kudos
Reply