UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Adventurer
Adventurer
63 Views
Registered: ‎03-27-2019

zynqmp uboot panic Insufficient RAM for page table: 0x15000 > 0x14000

After setting ip in uboot and pinging pc, the following message pops up and reboots. 2018.2 I am using uboot source and zynqmp. What's wrong?

saw the link below. But that link is 2016.4 and the guided answer is already reflected in 2018.2. (https://forums.xilinx.com/t5/Embedded-Linux/ZCU102-Petalinux-2016-4-U-Boot-fails-with-Insufficient-RAM-for/td-p/747161)

U-Boot 2018.01-00073-g21812b5fd3 (Aug 21 2019 - 10:54:36 +0900) Xilinx ZynqMP ZCU102 rev1.0

I2C:   ready
DRAM:  1023 MiB
EL Level:       EL2
Chip ID:        zu11eg
NAND:  512 MiB
*** Warning - bad CRC, using default environment

## Error: flags type check failure for "serverip" <= "AUTO" (type: i)
himport_r: can't insert "serverip=AUTO" into hash table
In:    serial@ff000000
Out:   serial@ff000000
Err:   serial@ff000000
Board: Xilinx ZynqMP
Bootmode: NAND_MODE
Net:   ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
PHY is not detected
GEM PHY init failed
No ethernet found.
U-BOOT for sw

ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
No ethernet found.
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
Hit any key to stop autoboot:  0
ZynqMP> setenv ipaddr 12.12.12.14
ZynqMP> ping 12.12.12.13
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
mdio_register: non unique device name 'eth0'
ZYNQ GEM: ff0c0000, phyaddr 5, interface rgmii-id
Insufficient RAM for page table: 0x15000 > 0x14000. Please increase the size in get_page_table_size()
resetting ...
Xilinx Zynq MP First Stage Boot Loader
Release 2018.2   Aug 21 2019  -  08:28:30
Manufacturer: MICRON      MT29F4G08ABAFAWP    ,
Device Model: MT29F4G08ABAFAWP    ,
Jedec ID: 0x2C
Bytes Per Page: 0x1000
Spare Bytes Per Page: 0x100
Pages Per Block: 0x40
0 Kudos