UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor matthijsw
Visitor
2,577 Views
Registered: ‎05-16-2013

ZYNQ- AXI Performance Monitor

i want to capture the first write flag of a axi interface with a AXI performance monitor. I already got the amount of data send through the axi interface, but i want to capture the start of the written data by using the first write flag and last write flag. but i dont understand the steps after step 6.

 

 

 

The following steps are recommended for all designs using Event Log logic of the

Performance Monitor:

1. Instantiate the Performance Monitor core in any system.

2. Configure the core based on the agents connected to the monitor slots.

3. Verify

CORE_ACLK is the fastest clock in the design.

4. Program the configuration registers.

5. Enable the Event Log bit in Control register.

6. Enable the required flags to capture events in the Event Log through the Flag Enable

register.

7. Load the target metric counts in the Metric Count Log Enable register

x and set the

corresponding flag for cross probing. If the metric count reaches the cut off count given,

then it automatically starts the event logging.

8. Read out the data from streaming interface of the core.

 

 

 is there anyone who could help me with this. 

 

i working a zynq on a Zedboard, ISE14.5, AXI performance Monitor IP V3.00

0 Kudos
1 Reply
Newbie nareshch
Newbie
755 Views
Registered: ‎05-25-2017

Re: ZYNQ- AXI Performance Monitor

I have configured the APM in trace mode, but i didn't understand the Log data,any one can help me plz.

0 Kudos