UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer yaserma1970
Observer
317 Views
Registered: ‎10-16-2019

AXI Ethernet Subsystem

I am using the AXI Ethernet Subsystems for a SFP port. The SFP port will be connected via copper connector to a FireFly optical transceiver. For Artix 7, which propotcol shall I use 1000_BaseX or SGMII?

0 Kudos
8 Replies
Adventurer
Adventurer
265 Views
Registered: ‎08-14-2013

Re: AXI Ethernet Subsystem

Probably 1000 base X. What's on the other end of the link?
0 Kudos
Observer yaserma1970
Observer
213 Views
Registered: ‎10-16-2019

Re: AXI Ethernet Subsystem

FPGA_SFP (FPGA board) --> Copper Cable (FPGA board) --> Optical Transceiver FireFly (FPGA board) --------> Optical Cable (about 150 cm) --> Optical Transceiver (a different board)

I do not have much info about the other board, but it is an optical transceiver that we are connecting to on the other end.

Hope this answers your question.

Thanks,

0 Kudos
Adventurer
Adventurer
173 Views
Registered: ‎08-14-2013

Re: AXI Ethernet Subsystem

Well, it's impossible to answer the question without knowing more about the other board. The correct setting is whatever the other board expects.
0 Kudos
Observer yaserma1970
Observer
103 Views
Registered: ‎10-16-2019

Re: AXI Ethernet Subsystem

The other end is an optical firefly transceiver. Is that enough info?

0 Kudos
Adventurer
Adventurer
83 Views
Registered: ‎08-14-2013

Re: AXI Ethernet Subsystem

No. The question is what protocol whatever is on the other end is expecting. Firefly just gives you O-E and E-O. On the other end will be a another chip of some sort with a SERDES and some logic behind that. What is that logic expecting? Is that another FPGA? Is it a standard network interface, such as a switch chip? How is it going to be configured?
0 Kudos
Observer yaserma1970
Observer
77 Views
Registered: ‎10-16-2019

Re: AXI Ethernet Subsystem

It is UDP over ethernet via fiber optic cable. The specifics of the receiving device itself should not matter.
0 Kudos
Adventurer
Adventurer
74 Views
Registered: ‎08-14-2013

Re: AXI Ethernet Subsystem

The only specific that matters is what line protocol it expects. If the other end expects SGMII, then use SGMII. If it expects 1000 BASE-X, then use that. Nobody on this forum can tell you what you need to use without more information about the device on the other end. Alternatively, if you are unwilling or unable to provide the necessary information, there are only a couple of options...take a guess, see if it works, try another setting if it doesn't.
0 Kudos
Observer yaserma1970
Observer
71 Views
Registered: ‎10-16-2019

Re: AXI Ethernet Subsystem

Thank you
0 Kudos