cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer
Observer
162 Views
Registered: ‎05-10-2013

Mismatch between User Guide and XDC/Board files for VCU128

Jump to solution

If you check the user guide for the VCU128 board on page  71, there is a mismatch in the pin location with respect to the XDC and board schematic.

e.g. `ENET_SGMII_CLK_P` is set to pin BH27 on the XDC, but the user guide says it's on pin BK23.

 

Which document has the correct information?

 

Thank you.

-- Paolo

0 Kudos
1 Solution

Accepted Solutions
Highlighted
135 Views
Registered: ‎01-22-2015

Re: Mismatch between User Guide and XDC/Board files for VCU128

Jump to solution

Paolo,

Both the schematic and the XDC file for the VCU128 board show that  "ENET_SGMII_CLK_P" corresponds to pin BH27.   Because of this, I suspect that BH27 is the correct pin number - and not BK23 as shown in the User Guide.

vcu128_schem.jpg

Cheers,
Mark

 

View solution in original post

1 Reply
Highlighted
136 Views
Registered: ‎01-22-2015

Re: Mismatch between User Guide and XDC/Board files for VCU128

Jump to solution

Paolo,

Both the schematic and the XDC file for the VCU128 board show that  "ENET_SGMII_CLK_P" corresponds to pin BH27.   Because of this, I suspect that BH27 is the correct pin number - and not BK23 as shown in the User Guide.

vcu128_schem.jpg

Cheers,
Mark

 

View solution in original post