UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Adventurer
Adventurer
388 Views
Registered: ‎04-25-2017

microblaze is in constant reset after adding 10G/25G ethernet subsystem

Jump to solution

We've a base microblaze design running linux which has been tried and tested on our custom board. After adding the 10G/25G ethernet subsystem(design similar to the image, I can't share our design), microblaze is in constant reset. Petalinux-QEMU fails, baremetal application helloWorld gives the same error. petalinuxbuild passes, bitfile generation does not show any errors. How can 10G IP reset microblaze?

10G_design.png
0 Kudos
1 Solution

Accepted Solutions
Highlighted
Adventurer
Adventurer
322 Views
Registered: ‎04-25-2017

Re: microblaze is in constant reset after adding 10G/25G ethernet subsystem

Jump to solution
As you said, there was a bad connection at the processor system reset.
0 Kudos
2 Replies
Scholar drjohnsmith
Scholar
378 Views
Registered: ‎07-09-2009

Re: microblaze is in constant reset after adding 10G/25G ethernet subsystem

Jump to solution
From what you describe
it could be anything.... most likely a bad connection some where,
simulation starts OK ?
<== If this was helpful, please feel free to give Kudos, and close if it answers your question ==>
0 Kudos
Highlighted
Adventurer
Adventurer
323 Views
Registered: ‎04-25-2017

Re: microblaze is in constant reset after adding 10G/25G ethernet subsystem

Jump to solution
As you said, there was a bad connection at the processor system reset.
0 Kudos