cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Explorer
Explorer
293 Views
Registered: ‎05-03-2018

mpsoc multiple network port settings

When setting the gem network port on the ps side of the mpsoc device, as shown in the figure, it is found that if the MDIO of gem3 uses mio77-76, the MDIO of gem0 cannot use mio77-76, which is whether the MDIO of gem0 can pass EMIO connects it to the external network port phy.

MDIO.jpg

0 Kudos
1 Reply
Highlighted
Moderator
Moderator
225 Views
Registered: ‎08-25-2009

Hi @shiyangcool ,

What is your concern here? I am not sure the exact issue/question you are asking.

On ZCU102, GEM3 is hard wired to the on board RGMII TI PHY. And MDIO can be used as shared MDIO line.

 

"Don't forget to reply, kudo and accept as solution."
0 Kudos