UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Visitor chulhoon
Visitor
238 Views
Registered: ‎03-26-2019

Firmware Update for ZCU102 EVB

Jump to solution

Hi, I am trying to update the firmware of ZCU102 EVB following xtp433-zcu102-system-controller-c-2018-3.pdf, but I failed. I set SW6 as Up and connected jumpers in J164 properly. What is the problem?

failed.png

0 Kudos
1 Solution

Accepted Solutions
Xilinx Employee
Xilinx Employee
178 Views
Registered: ‎06-06-2018

Re: Firmware Update for ZCU102 EVB

Jump to solution

hi @chulhoon ,

if you dont have further queries, please close this thread, by marking the post which helped you as accepted solution.

regrds,

Deepak

4 Replies
Xilinx Employee
Xilinx Employee
216 Views
Registered: ‎06-06-2018

Re: Firmware Update for ZCU102 EVB

Jump to solution

Hi @chulhoon ,

What is the revision version of the board?

When you power up the ZCU102, open a terminal window (whether TeraTerm, Putty, etc.) connected to Interface 3.  At the prompt type '@ver'.  

This will give you the version of the firmware on the particular board you have and will represent a date, for example 5/17, 7/5 etc.

1.JPG

Please share me what is the date you observed?

If it is May 17 2017 or earlier.

Please share your Registered Mail ID I will forward you the steps for firmware update through EZMove Software.

Regards,

Deepak D N

---------------------------------------------------------------------------------------------------

Please reply or give kudo or Accept as a Solution.

----------------------------------------------------------------------------------------------------

Highlighted
Visitor chulhoon
Visitor
197 Views
Registered: ‎03-26-2019

Re: Firmware Update for ZCU102 EVB

Jump to solution

Hi, @ddn .

This is the version information. My e-mail address is chulhoon.jang@magna.com.

ZCU102_version.png

Thank you for your support.

 

 

 

0 Kudos
Xilinx Employee
Xilinx Employee
192 Views
Registered: ‎06-06-2018

Re: Firmware Update for ZCU102 EVB

Jump to solution

Hi @chulhoon ,

I have sent you the Package/Files through EZMove software to your mail ID.

Regards,

Deepak D N

----------------------------------------------------------------

Please Kudo and Accept as Solution, if it helped.

------------------------------------------------------------------

Xilinx Employee
Xilinx Employee
179 Views
Registered: ‎06-06-2018

Re: Firmware Update for ZCU102 EVB

Jump to solution

hi @chulhoon ,

if you dont have further queries, please close this thread, by marking the post which helped you as accepted solution.

regrds,

Deepak