UPGRADE YOUR BROWSER

We have detected your current browser version is not the latest one. Xilinx.com uses the latest web technologies to bring you the best online experience possible. Please upgrade to a Xilinx.com supported browser:Chrome, Firefox, Internet Explorer 11, Safari. Thank you!

cancel
Showing results for 
Search instead for 
Did you mean: 
Highlighted
Observer jialf521
Observer
378 Views
Registered: ‎06-02-2018

Si5341B-B05071-GM

Jump to solution

   

      Is the si5341b-b05071-gm chip used on ZCU102 a custom chip purchased from Silicon Labs by XILINX? Does this chip require programming?

0 Kudos
1 Solution

Accepted Solutions
Observer jialf521
Observer
318 Views
Registered: ‎06-02-2018

Re: Si5341B-B05071-GM

Jump to solution

Thank you @thakurr

 SI5341BB05071-GM is The Custom Factory Preprogrammed Devices.The frequency of the output is what we want, we can just replace it without programming.

Thanks

0 Kudos
4 Replies
Moderator
Moderator
364 Views
Registered: ‎09-15-2016

Re: Si5341B-B05071-GM

Jump to solution

Hi @jialf521

Yes, Si5341b is is a one-time programmable clock source. This is configured using ClockBuilderPro software from Silicon labs.

si53400.JPG

Refer the below data sheet:

https://www.silabs.com/documents/public/data-sheets/Si5341-40-D-DataSheet.pdf

Regards
Rohit
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

0 Kudos
Observer jialf521
Observer
354 Views
Registered: ‎06-02-2018

Re: Si5341B-B05071-GM

Jump to solution

Thank you for your answer @thakurr

    According to the manual, the chip with the XXXX number is already a new film customized by the factory. Does this mean that the chip has met some output clock? If this chip needs to be reprogrammed, the corresponding register configuration file is not found on XILINX official website.

Thanks

 The following screenshot is from  Si5341-40-D-RM.pdf  page 56

捕获.PNG

0 Kudos
Moderator
Moderator
341 Views
Registered: ‎09-15-2016

Re: Si5341B-B05071-GM

Jump to solution

Hi @jialf521

Thanks for the pointers. As already mentioned there Si5340 B comes as either base devices (Programmed through SPI interface) or factory programmed devices (programmed Clock builder Pro software). Since this device is one time programmable (which has been mentioned in UG1182, page 44), if you need any additional feature or setting which is not there in CB pro software then you can request to Silicon lab before pre-programming:

pre-programmm.JPG

You can further contact Silicon labs support to get a confirmation on the re-programming thing (i am just telling you what has been mentioned in our UG)

Regards
Rohit
----------------------------------------------------------------------------------------------
Kindly note- Please mark the Answer as "Accept as solution" if information provided is helpful.

Give Kudos to a post which you think is helpful and reply oriented.
----------------------------------------------------------------------------------------------

0 Kudos
Observer jialf521
Observer
319 Views
Registered: ‎06-02-2018

Re: Si5341B-B05071-GM

Jump to solution

Thank you @thakurr

 SI5341BB05071-GM is The Custom Factory Preprogrammed Devices.The frequency of the output is what we want, we can just replace it without programming.

Thanks

0 Kudos