cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
zstibi
Visitor
Visitor
2,081 Views
Registered: ‎06-15-2019

Artix-7 and JTAG programmers compatibility

Jump to solution

Is Platform Cable (not II, but DS300) compatible with Artix7 FPGA family and Vivado IDE?

If not, then which programmer device should I use?

 

Thanks,

Tibor

0 Kudos
1 Solution

Accepted Solutions
2,063 Views
Registered: ‎01-22-2015

@zstibi 

Welcome to the Xilinx Forum!

Xilinx document UG908 (page 24) shows the programmers supported by the Vivado IDE v2019.1, which are:

• Xilinx® SmartLynq Data Cable (HW-SMARTLYNQ-G/DLC20)
• Xilinx Platform Cable USB II (DLC10)
• Xilinx Platform Cable USB (DLC9G, DLC9LP, DLC9)
• Digilent JTAG-HS1
• Digilent JTAG-HS2
• Digilent JTAG-HS3
• Digilent JTAG-SMT1
• Digilent JTAG-SMT2

These programmers can be used to program the Artix-7 FPGA.

Cheers,
Mark

View solution in original post

2 Replies
2,064 Views
Registered: ‎01-22-2015

@zstibi 

Welcome to the Xilinx Forum!

Xilinx document UG908 (page 24) shows the programmers supported by the Vivado IDE v2019.1, which are:

• Xilinx® SmartLynq Data Cable (HW-SMARTLYNQ-G/DLC20)
• Xilinx Platform Cable USB II (DLC10)
• Xilinx Platform Cable USB (DLC9G, DLC9LP, DLC9)
• Digilent JTAG-HS1
• Digilent JTAG-HS2
• Digilent JTAG-HS3
• Digilent JTAG-SMT1
• Digilent JTAG-SMT2

These programmers can be used to program the Artix-7 FPGA.

Cheers,
Mark

View solution in original post

zstibi
Visitor
Visitor
2,010 Views
Registered: ‎06-15-2019

Thank you for the satisfactory answer!

0 Kudos