cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
Highlighted
Observer
Observer
254 Views
Registered: ‎07-02-2019

Booting device from configuration memory failed

Jump to solution

After programmed flash memory with a .mcf file, then boot from the flash memory, but failed. No other error information. Any ideas what's wrong? Thanks.

Capture.PNG

0 Kudos
1 Solution

Accepted Solutions
Highlighted
Observer
Observer
187 Views
Registered: ‎07-02-2019

Thank you for your reply.

Earlier the FPGA_M[2:0] was set as "111" by mistake, the boot from flash memory works after set it as "001".

View solution in original post

0 Kudos
2 Replies
Highlighted
Xilinx Employee
Xilinx Employee
208 Views
Registered: ‎08-10-2008

You should always tell what FPGA and flash you are using for a configuration question; and then, read the status register after the failure.

------------------------------------------------------------------------------------------------------------
Don't forget to reply, kudo, and accept as solution.
---------------------------------------------------------------------------------------------------------
0 Kudos
Highlighted
Observer
Observer
188 Views
Registered: ‎07-02-2019

Thank you for your reply.

Earlier the FPGA_M[2:0] was set as "111" by mistake, the boot from flash memory works after set it as "001".

View solution in original post

0 Kudos