cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
sjacq
Observer
Observer
230 Views
Registered: ‎01-08-2009

Can't program VCU128 with FMC board

Jump to solution

Hello,

We are trying to use the VCU128 (rev 1.1) with an SD card adapter connected to the FMC XM105 Debug Card. When we plug the FMC board with our SD card adapter, we can't program the board anymore via JTAG : vivado tells us that the cable is not connected. It works perfectly fine without the FMC board.

Is there something to configure somewhere to use the FMC debug card that we missed ?

crdly,

Sebastien

Tags (3)
0 Kudos
1 Solution

Accepted Solutions
ddn
Moderator
Moderator
219 Views
Registered: ‎06-06-2018

@sjacq ,

Please refer this https://www.xilinx.com/support/answers/52888.html and put the jumper on XM105 fmc card to establish the JTAG Chain.

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post

2 Replies
ddn
Moderator
Moderator
220 Views
Registered: ‎06-06-2018

@sjacq ,

Please refer this https://www.xilinx.com/support/answers/52888.html and put the jumper on XM105 fmc card to establish the JTAG Chain.

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post

sjacq
Observer
Observer
203 Views
Registered: ‎01-08-2009

Thanks !

It's working fine now, indeed by shunting those two pins, the JTAG chain is working again !

Bests,

Sébastien

0 Kudos