cancel
Showing results for 
Show  only  | Search instead for 
Did you mean: 
andy.klaib
Visitor
Visitor
153 Views
Registered: ‎03-18-2019

Dual Parallel QSPI on Kintex-7

Jump to solution

I'm using the GTX transceivers on a Kintex-7 (Trenz Electronic TE0741) for a project, and I'm looking into some options for storing the large files to transmit. I'm considering using two external QSPI flash in parallel (to increase throughput) on a carrier board. Would this be a viable option?

 

These two flash chips would be separate from the QSPI flash used for configuration.

0 Kudos
1 Solution

Accepted Solutions
ddn
Moderator
Moderator
144 Views
Registered: ‎06-06-2018

@andy.klaib ,

For 7 series device x8 SPI or dual parallel mode is not supported. For supported SPI Modes refer UG470 (v1.13.1).

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post

1 Reply
ddn
Moderator
Moderator
145 Views
Registered: ‎06-06-2018

@andy.klaib ,

For 7 series device x8 SPI or dual parallel mode is not supported. For supported SPI Modes refer UG470 (v1.13.1).

Regards,
Deepak D N
---------------------------------------------------------------------------
Please Kudo and Accept as a Solution, If it helps.
---------------------------------------------------------------------------

View solution in original post